23
5.2.14 In order to assemble the rear cowl, place it behind frame 1, then insert the cardan shaft 18. Use the
relevant pins 2 and 9 to fasten arms 3 and 10 to the frame 1, whereas pins 4 are assembled to control oscil-
lation. Assemble arms 3 inside the cowl brackets with a hole A and insert pin 14 and arms 10 into hole B.
Arm 10 must be assembled using screw 17 and nut 19. Some play must be left without tightening them com-
pletely.
Warning: the diagram shows a rear cowl with straight axles, for SM/3600. In fact the rear cowls for the
SM/4500 and the SM/5200 have axles shared in two pieces.
5.2.15 In order to assemble the side cowls, place the lower hole of frame 1 to match hole A on the cowl and
then insert pin 6 and lock split pin 7. Then use pin 3 to fasten the tie rods 2 and match the rear hole to hole B
on the cowl. There assemble a screws 8 and nut 9, do not lock nut 9, tie rods 2 to be free. Assemble the car-
dan shaft.
