18
5.2.4
Fit the wheel units 2 to their correct mountings on the axles 1. Connect
the shim 3 (D 30/40x12 - D 1"3/16x1"9/16x1/2") to the axle on wheel unit 2. The shim is selected according
to the required cutting height (see page 31), therefore what we are describing is an example.
Next, the wheel unit 2,
onto which the shim 3 has
been secured, must be
connected to the correct
seat on the axles 1. Now
fasten onto the axle of the
wheel unit 2 the shims:
item 4 (D 30/40x32 - D
1"3/16x1"9/16x1x1”1/4)
item 5 (D 30/40x25 -D
1"3/16x1"9/16x1") n° 3 pz
item 6 (D 30/40x6 - D
1"3/16x1"9/16x1/4)
item 7 (D 30/40x2 - D
1"3/16x1"9/16x5/64).
At this stage secure eve-
rything with the split pins
8. Fit the grease nipples 9
to the correct positions on
the axles 1.
For this step you will use:
Item 8: n° 4 - split pins
D 8 (5/16)
Item 9: n° 4 - grease nip-
ples M6 (15/64)
For the rear mower, repeat the assembly instructions given above but assemble the wheel clamp with the
hexagonal pintle on the front part. Assemble the bushings with an enlarged hole on to the pintle.
5.2.5
Use the screws 3 (M16x45)
and the nuts 4 (M16) to fas-
ten the draw-bar 1 to the
main frame 2. The screws
must be inserted as shown
in the diagram.
Use the screws 6 (M16x140)
and the nuts 4 (M16) to fas-
ten the rear crosspiece 9 to
the main frame with plate 10.
Use the same type of screws
to assemble the wheel arms.
5.5
