Sitepower SPG8000, Инструкция по эксплуатации

Страница: 15 / 18

14
3. Reinstall the filter, O-ring, and sediment cup.
4. Turn the fuel valve lever ON and check
For leaks.
Spark Plug Service
To ensure proper engine operation, the spark plug
must be properly gapped and free of deposits.
If the engine has been running, the muffler will
be very hot. Be careful not to touch the muffler.
1. Remove the spark plug cap.
2. Clean any dirt from around the spark plug base.
3. Use a spark plug wrench to remove the spark plug.
4. Visually inspect the spark plug. Discard it if the
insulator is cracked, chipped or fouled.
5. Measure the plug gap with a feeler gauge.
Correct as necessary by carefully bending
the side electrode.
The gap should be: 0.028 0.031 in (0.70 0.80 mm)
6. Check that the spark plug washer is in good
condition, and thread the spark plug in by hand to
prevent cross-threading.
7. After the spark plug is seated, tighten with a spark plug
wrench to compress the washer.
－
If installing a new spark plug, tighten 1/2 turn after the spark plug seats to compress the washer.
If reinstalling a used spark plug, tighten 1/8
－
1/4 turn after the spark plug seats to compress the
washer.
WARNING:
The spark plug must be securely tightened. An
improperly tightened spark plug can become
very hot and could damage the engine.Never
use spark plugs which have an improper heat
range.STORAGE
Before storing the unit for an extended period:
Be sure the storage area is free of excessive humidity and dust.
Service according to the table below:
☆
STORAGE
Before storing the unit for an extended period
：
Be sure the storage area is free of excessive humidity and dust
。
Service according to the table below