Sitepower SPG8000, Инструкция по эксплуатации

Страница: 10 / 18

9
2. Turn the fuel valve lever to the ON position.
3. The choke will be closed if the engine is cold, pull the choke rod out to the CLOSED position.
4. Turn the engine switch to the ON position.
5. Pull the starter grip lightly until resistance is felt, then pull briskly.
WARNING:
Do not allow the starter grip to snap back against the engine. Return it gently to prevent damage to
the starter.
6. If you have closed the choke, push it to the OPEN position as the engine warms up.
◆
ELECTRIC START
1. Make sure that the AC circuit breaker is in the OFF position. The generator may be hard to start if a load is
connected.
2. Turn the fuel valve lever to the ON position.
3. The choke will be closed if the engine is cold, pull the choke rod out to the CLOSED position.
4. Connect the battery cables to the generator.
5. Turn the engine switch to the START position and hold it there for 5 seconds or until the engine starts.
Operating Range
NOTE
：
Some precision equipment is voltage sensitive and may require a more uniform voltage supply than portable
generators provide
。
Examples include some medical equipment
，
personal computers
，
and some inverters that
sense peak and RMS voltage values
。
Consult the precision-equipment vendor before relying on any portable
generator to provide power to such equipment
。
Connection Alternating Current
（
AC
）
●
Be sure all electric devices including the lines and plug connections are in good condition before
connection to the generator
。
●
Be sure any electric devices are turned off before plugging it in
。
●
Be sure the total load is within generator rated output
。
●
Be sure the receptacle load current is within receptacle rated current
。
1. Wind the power lead 2 or 3 turns around frame
。
2. Start the engine
。
3. plug into AC receptacle
。
4. Make sure the voltage meter indicates the rated voltage
。
5. Turn the AC switch to the
“
ON
”
position and turn on any electric devices
。
WARNING:
Operating the starter motor for more than 5 seconds can damage the motor. If the engine fails to start,
release the switch and wait 10 seconds before operating the starter again.
If the speed of the starter motor drops after a period of time, it is an indication that the battery
should be recharged.
When the engine starts, allow the engine switch to return to the ON position.
6. If you have closed the choke, push it to the OPEN position as the engine warms up.