29
In Manual Sectors, each sector may be individually set to automatic,
manual operation or manual stop.
In Automatic, the sector will follow the commands from the irrigation
programs; in Manual Start, the sector remains active permanently, and in
Manual Stop, it remains stopped permanently.
Keep in mind that as long as a sector is not in automatic mode, it
means the programs it contains will be conditionally stopped; when it is
switched back to automatic, the programs will continue at the same point
if they were irrigating or with the all the units if they have not yet been started. A sector in Manual Start will activate
the motor and count up the corresponding irrigation units; only global determining factors will affect it.
The manual erasure function sets the irrigation or fertilizer time and
volume totals to zero, saving the date when this is done.
If the access code is activated in the section “Parameters - Installer”, it
will be requested here.
In the section on manual outputs, the devices connected to them can
be activated. It is necessary to do this carefully, as there is no control over
this type of function and the installation may be damaged (it does not take
into account any safety devices). This function is only to be used by the
installer in the initial start-up procedure.
As
many
as
6
outputs
can
be
activated
and
to
exit,
all
must
be
left
at
0.
To remove an output from the list, the number will appear again.
To consult the allocation of the general outputs, on the equipment go to
“
Parameters -
General”
[6.3.] or see
the list of notes in the same section of this manual.
MANUAL SECTORS
Sector: 01
In automatic: yes
In manual: [Start]
[Stop]
TOTALS ERASURE
Totals Erasure: no
MANUAL OUTPUTS
Output: 00003
00001 00000 00000
00000 00000 00000