Siruba HSM-2517, Инструкция по эксплуатации

Страница: 17 / 24

-16-
Thread tension dial
Stitch length
0.5-1 1 2 3 4
Top side
Under side
thread must never appear on
the top of the fabric.
sewing speed, but the bobbin
on the thread, fabric and
on the under side depending
The top thread may appear
ZIGZAG STITCHING
Stitch Selector B
Stitch Width 1-5
Stitch Length 1-4
Use a backing stabilizer interfacing for the sheer
materials to avoid puckering.
tension for satin stitching.
This is a closely spaced attractive stitch used for
applique,bar-tacking,etc. Slightly loosen top thread
SATIN STITCH
figure 3.Turn the hand wheel to take a few stitches and
(Fig.3)
4.Press both sides of the finished hem.The right side should
barely show the stitches.
titch just catches the fold.
turn the screw on the foot to adjust the guide so the s-
(Fig.4)
of the hem against the guide in the foot as illustrated in
3.Place the wrong side of the garment under the blind hem
presser foot with the extension to the right and the fold
side leaving about 1/4 inch of the wrong side of the hem
edge extending.Figure 2.
2.Press the hem in place.Fold the hem toward the right
zag to overcast the edge).Figure 1.
inch to the wrong side,for heavier fabric,use multiple zig
1.First finish the hem edge(for lightweight fabric,press 1/4
Stitch Selector C,F
Stitch Width 1-5
Stitch Length 1-4
BLIND STITCH
C
F
(Fig.1) (Fig.2)
6mm(1/4")
1
0
Stitch indicator
B