Siruba HSM-2517, Инструкция по эксплуатации

Страница: 11 / 24

-10-
6.REVERSE STITCH LEVER
It is recommended to begin, or end seams with several stitches
in reverse
for reinforcement. As long as you are pressing down this lever
while sewing, the machine will continue to feed the fabric
backwards.
4
2
1
3
to S mark where fine adjustment can be made.
Super (stretch) stitch patterns can be selected by turning the same
dial
and type of fabric.
Stitch length can be selected easily according to thickness
5.STITCH LENGTH / SUPER (STRETCH) STITCH DIAL
2.Then turn the selector until the required stitch is indicated on
the indicator
1.To select a stitch, be sure needle is out of fabric at its highest
position.
4.STITCH SELECTOR AND INDICATOR
5
4
panel.
6
3.STITCH WIDTH / NEEDLE POSITION DIAL
shows the center position.
with the same control dial. The triangle marking between 2 and 3
The width of all the stitches produced on this machine can be
made narrower or wider by adjusting the stitch width control.
When sewing straight stitching, you can select various needle
positions from 0 (right needle position) to 5 (left needle position)
2
thick fabric.
3.Lift it to its highest position to change the presser foot or
to remove
2.Raise the lever to the middle position to insert or remoye
fabric.
1.Lower the presser foot to sew.
There are three positions for your presser foot.
2.PRESSER FOOT LEVER
The higher the number,the tighter the tension.
Decrease or increase the tension of the top thread by
using this control.
1.ADJUSTING TOP THREAD TENSION
4
2
1
2
3
4
3
M
L
5
3
-
S
+
F