5
If soot or other foreign matter has become mixed
with the granular materials and cannot be removed
by hand, remove the contaminated layer and
replace with a clean layer from the bag of granules
supplied with the fire. When levelling ensure that
none of the granules are pushed into the pilot
burner outlet.
If large pieces of debris are found any where in the
fireplace, the chimney and appliance should be
inspected and serviced by a competent person
before further use.
OPERATING INSTRUCTIONS -
Remote Control Version
TO LIGHT THE FIRE
(Ensure the battery is connected and batteries are
also in the handset
)
To light the fire, point the handset to the sensor on
the front your fire. Push and hold the two buttons
together, on the left hand side of the handset. The
fire will give out a beep sound and you can release
the buttons. After a few seconds you will hear the
clicking spark to the pilot light. Once the pilot is lit
the fire main burner will come on to the high
position (this whole process will take no more than
20 seconds).
TO SELECT THE REQUIRED FLAME
LEVEL
To turn down the fire, point the handset to the
sensor on your fire then push and hold the minus
button (small flame), if you release immediately
the flame will go to low if you hold the flame will
lower slowly and you can release the button to
your desired position.
To turn the fire up, point at the sensor, push the
plus button until the desired flame height is
reached.
The fire may be left in the standby mode (pilot
only) by pressing the small round button on the
handset.
TO TURN OFF
To turn your fire off, point the handset at the
sensor and push the top left button. The
fire will go out.
OXYGEN DEPLETION SYSTEM
If the Oxygen Depletion System (ODS) operates,
i.e. shuts off the gas supply to the fire, WAIT FOR
THREE MINUTES and follow the operating
instructions on pages 4 and 5.
The ODS is designed to shut off the gas supply to
the burner if the oxygen content of the room falls
below a certain level. If it continues to operate then
contact your installer to have the fire and flue
system checked.
SERVICING AND MAINTENANCE
If your fire requires servicing or maintenance,
please contact your supplier quoting the model
name (Streamline 3) and the serial number. Both
of which can be found on the data badge, which is
located next to the control knob behind the ash
pan cover.
BATTERY REPLACEMENT
USE ALKALINE BATTERIES ONLY (9 Volt PP3)
IN THE HANDSET
VI-06-09
