21
11
MAINTENANCE SPARES
During servicing and maintenance your appliance may need some replacement parts. Here
is a short list of spare parts that are available:
Supplier Ref.
Description
Manufacturers Part No.
Coals Kit
Pebbles Kit
Logs Kit
Granule Kit
1097-1
Ember Kit
1098-1
V4-28
Gas Tap GH-687-004-001
1087-1
P4-10
Co-pilot NG20/H/320/M8/A
1091-1
Remote Battery Pack
Remote Handset
K1-32
Control Knob
1096-1
Please contact SIROCCO if other parts are required.
12
FAULT FINDING
FAULT
CAUSE / POSSIBLE REMEDY
Pilot will not light.
See Ignition Functional Check 1.
No spark.
See Ignition Functional Check 2.
Pilot will not stay lit or fire goes
out in use.
See Flame Failure Functional Check.
Uneven flame pattern e.g. flame
at one side only.
1. The fuel effect may need adjusting to even the flame pattern. See pages
9 – 15.
Blue flames.
1. The fire will burn blue on initial lighting, until sufficient heat is generated
causing the flames to burn yellow. Typically 10 – 20 minutes.
2. Insufficient gas pressure. Check the supply pressure to the appliance.
3. The primary aeration may be obstructed by dirt, lint, etc. Clean and re-
check.
Low flame height.
1. Insufficient gas pressure. Check the supply pressure to the appliance.
2. The visual effect is controlled by the placement of the fuel effect pieces.
Try slight adjustments. See pages 9 – 15.
Popping noises.
1. Some popping noises will always be present. Severe popping may be
caused by incorrect gas pressure. Check the supply pressure to the
appliance.
2. Incorrect amount of granular material in the burner tray. See section 6.6
on page 8.
3. Try slight adjustments to the fuel effect pieces. See pages 9 – 15.
VI-06-09
