10
Do not pull the feeding cable to un-
plug (Fig. 21).
Check the status of the feeding ca-
ble on regular basis as a worn out
cable or imperfect presents serious
electrical dangers.
If the machine remains unutilised for
a long time, have it checked by an
Customer Service Centre before us-
ing it.
If the machine shows signs of mal-
functioning, it is recommended to
switch it off, not to use it and not to
intervene directly.
to repair it and call the Customer
Service Centre whose details can
be seen at the back of this manual.
In case of fall or immersion of the
blender, do not use it and contact
CUSTOMER SERVICE immediately
to have a detailed check.
Do not leave the dipping blender
plugged in pointlessly. Unplug it
when not using the machine. (Fig.
22).
Do not hang f handle the dipping
blender by means of the feeding ca-
ble (Fig. 23).
Even if the machine is built accord-
ing to the enforcing laws, there are
some dangerous zones. Therefore,
it is recommended to avoid to ap-
proach the hands to the blades or
other parts in movement (Fig. 24).
Do not posture in such a way that
might lead parts of the body in
direct contact with the blades.
Fig. n°21
Fig. n°22
Fig. n°23
Fig. n°24
15
5.2 - PREPARATORY CHECK
Check that the tools are perfectly as-
sembled as per
chapter 5.
Check that the electrical connections
has been done correctly as per
para-
graph 2.3.
Hold the machine with a hand and after
that check its functioning with the fol-
lowing procedure
(Fig. n°32-33)
:
-
Ensure that the switch (1) is not
pushed
-
Insert the machine’s plug into the
socket
-
Hold the blade unit near the table, in
any case away from utensils, gar-
ments and parts of the body.
-
Press the power button (1). The ma-
chine will start to work.
-
If the machine is normal the engine
5.1 - ACCESSORIES ASSEMBLY:
The tools must be installed on the en-
gine’s body when the machine is un-
plugged.
All the dipping blender’s tools are per-
fectly interchangeable. However, they
might differ according to the model,
date of production, producer. Hence, it
is recommended to keep separate the
various accessories of other dipping
blenders.
ENGINE’S BODY - SHAFT
(Fig. n°31)
Grip the engine’s body by the handle,
grip the shaft with the other hand. Align
the shaft’s rung to the clutch of the ma-
chine’s body (1). Insert the shaft deeply
(2) and rotate it of about 45° degrees
anticlockwise till the shaft is firmly
blocked to the machine (3). The catch
will fit the engine’s body reference.
CHAP. 5 - USE OF THE MACHINE
(1) (2)
(3)
Fig. n°31
Fig. n°32
