16
Installation and Setup
If you are installing the antenna at the roof edge, or hood edge, install the Cable
Routing Adapter to direct the antenna cable downward.
Recommended Antenna Cable Routing
Press the antenna wire under the rubber molding around the front windshield to
the nearest corner. Then route the cable out of the windshield molding and into
the rubber weather stripping around the door opening. Lift the weather stripping
from the opening and tuck the cable inside it, then replace the weather stripping.
Run the cable inside of the weather stripping to the bottom of the door opening.
Hide the antenna wire inside the cabin. Pull the cable out of the weather stripping
at the bottom of the door opening and route it under the carpet toward the
cigarette lighter power adapter socket. Coil any excess cable in a hidden location,
Place the antenna wire
into the groove of the
Cable Routing Adapter
Slide the Cable Routing Adapt-
er down the antenna wire and
press it into the antenna until
it is flush with the bottom of
the antenna
Without Cable
Routing Adapter
Installed
With Cable
Routing Adapter
Installed
Cable Routing
Adapter orientation
Содержание Snap!
