SIP 06434, Инструкция по эксплуатации и техническому обслуживанию

Страница: 9 / 21

9
TIP! For loosening nuts, screws etc., it is not necessary to heat the material until it is red hot. Heat
the nut for 2 seconds and try to loosen it using a wrench. If it is not possible, heat again for 2 seconds
and then try loosening using the wrench again.
6.2 Flat coil
The flat spiral shaped coil is intended for the heating of flat sheet metals and for the straightening of
small dents in car bodies by heating. The flat coil is also intended for easy peeling off of stickers,
sealants, putties etc. by heating of the base material - steel sheet metal.
1. Connect the coil to the coil handle
2. Place the coil with its area over the material
3. Press the button and guide the coil above the material in a gyratory movement
4. After heating of the material, allow the coil to cool off for at least 2 minutes.
NOTE: It is possible to use the coil to remove various adhesive stickers, sealants and
gaskets which are stuck to sheet metal or metal – for example in automotive,
services etc. The coil is used heating of the base material and thus softening, or
alternatively, hardening of the glue, putty, etc. We recommend holding the coil
around 5-15mm far from the heated material - it is possible to regulate the required
temperature and heating time by changing the distance.