Sioux Automation Center TURBO-MAX 6141, Руководство оператора и каталог запасных частей

Страница: 16 / 48

Page 16
Wheel Bolts must be kept properly torqued. Damage to the rim may occur if wheel bolts are not checked fre-
quently.
8-bolt rim: 170 ft lbs-Grade 8 Lug
10-bolt rim: 300 ft lbs-Grade 8 Lug
Tire Wear and Pressure must be checked to ensure that there is no excessive wear, and that tires are infl ated
to the recommended operating pressure for each given tire.
Rain can accumulate in mixer if stored outside, always remove drain plugs on hopper ends to allow unit to
drain completely and replace drain plugs before next use.
Freezing Weather the PTO shield requires extra grease to prevent freezing. Snow can accumulate in mixer
if stored outside, always remove drain plugs on hopper ends to allow unit to drain completely and check hopper
for snow or ice buildup before operating unit. Thaw and remove any obstruction and replace drain plugs before
next use.
IMPORTANT: WHEN WELDING ON THIS UNIT: Do NOT allow the current to fl ow through the bearings,
roller chains, or scale weigh bars. Ground directly to the item being welded. ALWAYS disconnect weigh bar cords
from scale indicator before welding.
•
•
•
•
INSPECT AND ADJUST
INSPECTION AND ADJUSTMENTS
Scale Indicator: Refer to the electronic scale operators manual for adjustment information. The operator’s
manual for the Electroic Scales should be kept with this manual. Additional scale manuals may be obtained
through Sioux Automation Center, Inc.
Load Cells: Should be kept clean, dry,and lubricated to insure dependabiltiy.
Normal Scale Activity: Some warm up scale “drift” may occur after the scale is turned on but should zero
balance within 10-15 minutes. Scale may zero shift over night due to temperature changes.
•
•
•
ELECTRONIC SCALES