SioGreen SIO 14, Руководство по эксплуатации и установке

Страница: 4 / 22

2 | P a g e
INTRODUCTION
SioGreen Tankless hot water heaters do not store water like a conventional
tank-type water heater. It contains multiple high powered quartz heating tube
elements that are capable of heating water “on-demand” and continuously as
needed, so you will never have to worry about running out of hot water again.
The unit’s working principle and designs are simple. When the power is turned
on, the microprocessor will check the temperature sensor and current leakage
sensor, if there are no errors, the hot water generator is ready to work.
The performance of the products listed are dependent on incoming water
temp, water flow rate, and set temperature of the thermostat. In order for it
to function properly it must be matched by location, application, and unit size.
As it requires no venting, all units can be installed literally anywhere that is
convenient for the owner.
This product should be installed indoors only. An outdoor installation is
permitted as long as it is mounted in a suitable enclosure that protects it from
all-weather elements including freezing. Freezing of the unit may result in
permanent damage and will void the warranty.
Unit Operation:
When you open the hot water valve, the flow sensor activates at a minimum
water flow. The flow sensor sends the information to the temperature
controller to begin modulating the heating elements to heat the water as it
passes through the quartz heating tubes and to maximize efficiency.
If the water flow rate exceeds the maximum heating capacity of the unit, the
unit will reach a maximum achievable temperature based on flow rate and
unit size. When a reduction in the excessive flow rate is made, the unit will
achieve the set point temperature.
When the fixture is closed, the demand stops, the flow sensor sends
information to the controller to turn off the power to the quartz heating
elements. The unit remains in it standby mode until the demand for the hot
water is needed.