THERMAL RECEIPT PRINTER
52
• In standard mode, the horizontal motion unit is used.
• In page mode, the horizontal or vertical motion unit differs in page mode,
depending on starting position of the printable area as follows:
①
When the starting position is set to the upper left or lower right of the
printable area using
ESC T
, the horizontal motion unit ( x) is used.
②
When the starting position is set to the upper right or lower left of the
printable area using
ESC T
, the vertical motion unit ( y) is used.
③
The maximum right-side spacing is 255/180 inches for the paper roll and is
approximately 35.983 mm {255/150 inches}. Any setting exceeding the
maximum is converted to the maximum automatically.
[Default]
n1
= 0,
n2
= 0
[Reference]
GS P
FS W
n
[Name] Turn quadruple-size mode on/off for Kanji characters
[Format] ASCII FS W
n
Hex 1C 57
n
Decimal 28 87
n
[Range] 0
≤
n
≤
255
[Description] Turns quadruple-size mode on or off for Kanji characters.
• When the LSB of n is 0, quadruple-size mode for Kanji characters is turned off.
• When the LSB of n is 1, quadruple-size mode for Kanji characters is turned on.
[Details] • Only the lowest bit of
n
is valid.
• In quadruple-size mode, the printer prints the same size characters as when
double-width and double-height modes are both turned on.
• When quadruple-size mode is turned off using this command, the following
characters are printed in normal size.
• When some of the characters on a line are different in height, all the characters
on the line are aligned at the baseline.
•
FS !
or
GS !
can also select and cancel quadruple-size mode by selecting
double-height and double-width modes, and the setting of the last received
command is effective.
[Default]
n
= 0
[Reference]
FS !
,
GS !