Sinoboom GTJZ0608, Руководство по эксплуатации

Страница: 22 / 37

lift to the highest position. For weight more than
540kg, the platform lifting height is more than 1
m or 10% of the lifting height (larger) , the
overweight indicator lights on, and alarms ,the
workbench is prohibited from moving, after
removing the overloaded items, the movement
can start again
.
GTJZ1012
For weight less than 320kg, platform be able to
lift to the highest position. For weight
more than
380kg, the platform lifting height is more than 1
m or 10% of the lifting height (larger) , the
overweight indicator lights on, and alarms ,the
workbench is prohibited from moving, after
removing the overloaded items, the movement
can start again.
GTJZ1212
For weight less than 320kg, platform be able to
lift to the highest position. For weight
more than
380kg, the platform lifting height is more than 1
m or 10% of the lifting height (larger) , the
overweight indicator lights on, and alarms ,the
workbench is prohibited from moving, after
removing the overloaded items, the movement
can start again.
Test Limited Drive Speed
1. Press the lift button which shall flash.
2. Raise platform for about 1.5 meters.

Result: The pit protection mechanism
(located at the bottom of the chassis, each
one at right and left) should be expanded
3. Press the walking and steering buttons, and
slowly move the drive control handle to the
full drive position.

Result: The speed of machine movement
will be no more than 45 seconds when
walking 10m.
Attention: If the machine running 10m is less
than 45s, stop operation and mark immediately.
Test Level Sensor
Attention:
Use the platform controller to
control the equipment on the ground, no
operation allowed when standing in the platform.
1. Fully lower the platform.
2. For
GTJZ0608, GTJZ0808
Place two pieces of wood blocks with
height of 21mm and length & width of
50×100mm on the left side of the machine
(or right) under the two wheels, and drive
the machine on these two plates.
For GTJZ0612, GTJZ0812, GTJZ1012,
GTJZ1212
Place two pieces of wood blocks with
height of 30mm and length & width of
50×100mm on the left side of the machine
(or right) under the two wheels, and drive
the machine on these two plates.
3. Turn the walking function into platform
lifting/lowering function, and the handle is
lifted above the platform by about 2m.

Result: The platform should stop moving
and the tilt alarm will ring. The platform
and ground display should show LL.
4. Lower the platform, change to walking
function, remove work platform and
wooden blocks.
5. Place two pieces of wood blocks with
height of 100mm and length & width of
50×100mm in front of (or behind) the
machine under the two wheels, and drive
the machine on these two plates.
6. Turn the walking function into platform
lifting/lowering function, and the handle is
lifted above the platform by about 2m.

Result: The platform should stop moving
and the tilt alarm will ring. The platform
and ground display should show LL.
7. Lower the platform, change to walking
function, remove work platform and
wooden blocks.
20
GTJZ0608 & GTJZ0808 & GTJZ1012 & GTJZ1212 & GTJZ0612 & GTJZ0812
Operation Manual