6.4. START-UP
After turning on machine or line power, conduct a
careful visual inspection of the entire machine and
make sure that no persons or material are obstruct-
ing its normal operation, and that no objects have
inadvertently been left on it.
Check that all the machine safety devices are ena-
bled; if necessary, reset them, and in particular check
for:
• Unlocked emergency stops;
• Correct operation of the safety barriers, if installed,
or the guards not removed
• Protection guard.
6.5. NORMAL STOP
Turn the switch on the welder panel to OFF.
To completely disconnect the power supply from the
power line, turn the switch on the main panel to O.
6.6. DECOMMISSIONING
During long periods of inactivity it is necessary to:
- Disconnect the power supply from the gener-
al electrical panel and all other power supplies
(pneumatic and/or hydraulic) which the machine
needs.
- Perform all maintenance operations.
- Accurately clean the machine.
- Store the machine in a protected area with a sta-
ble support surface.
- Cover the machine to avoid dust accumulation.
- Make sure that the environmental conditions are
suitable for preserving the machine over time.
1.995.234 EN - Rev. 1.1
NOVAMIG 320 LCD
26
