Simrad ROBERTSON AP45, Инструкция по эксплуатации

Страница: 16 / 124

Page 2-2 Robertson AP45 Autopilot
Operation
Simrad Robertson AS
Egersund - Norway
Any difference between course to steer and the vessel's actual heading will then be
shown as a bargraph in the Information Display. One bar equals one degree.
Rudder commands are indicated by an arrow in the lower left or right corner of
the information display depending upon which direction the autopilot commands
the rudder to move.
WORK
The WORK-mode is an automatic mode to be used under operational conditions
different from those normally found when a vessel is under motor power on a
preset course. Examples are trawling, towing, sailing, slow speed etc.
In WORK-mode the PORT- and STBD-buttons can be used for immediate rudder
off-set (trim) if necessary. This manual off-set compensates for the built-in
autotrim which needs time to build up the appropriate off-set.
The Information Display shows the off-set value when the PORT- or STBD button
is pressed.
Boats under sail power and some trawlers may need a rudder off-set when steered
by hand. To avoid cancellation of the rudder off-set when changing to automatic
steering, the WORK-mode can be selected directly from MANUAL-mode. The
rudder off-set is then maintained as "on course" reference. This off-set is also
maintained when changing from WORK to NAV mode.
If the AUTO-mode is selected from MANUAL-mode, the rudder is first taken to
midposition before a sufficient off-set of the rudder is built-up automatically
(autotrim).
A different RUDDER value may be preferred in WORK-mode as compared to that
in AUTO-mode. The WORK-mode value will be stored in the AP45 memory for
later use.
Note!
Pair-trawling that requires manual trim only, will also require that the autotrim
be disabled. Refer to “Disengage of autotrim-function in WORK-mode”, page 6-5,
for specific details.
NAV
NAV-mode is used when a navigation receiver is connected to the autopilot for
automatic waypoint steering. To be able to use the NAV-mode with older AP45
(below s.n. 4000), the main PCB must be equipped with the N40 Navigation
Interface.
When the NAV-mode is selected, the AP45 automatically monitors the signals
from the navigation system. If the signals are absent or in a different format than
the data format selected in the AP45, an alarm will be given to alert the operator.
See “Navigating with the AP45” page 2-5.
OFF
The autopilot is switched off by pressing the OFF-button for 2 seconds, during
which time the alarm will sound. The alarm ceases when the AP45 is switched off.
If the OFF-button is released before two seconds have elapsed, the autopilot will
continue to operate as before and the alarm signal is automatically reset.
Rudder commands will stop as long as the OFF-button is pressed. All pre-set
parameters in the autopilot are stored while the unit is switched off.