Simrad Maris ECDIS900, Руководство по установке

Страница: 33 / 64

Page 33
MARIS ECDIS900 Installation Manual
1. Open the Inbox program.
Click “Tools/Options/Position Settings”. Select “Accept the Position from Sensor
Monitor”. Click “Ok”.
2. Click “Options/Expiry”.
Select “Enable Auto Check” and set it to 3 days.
3. Click “Tools/Options/Mailbase Path”.
Click “Browse” and point to C:\Program Files (x86)\MARIS\Navtex\InBox. Click “Ok”.
This concludes the Inbox setup.
4. Share the folder C:\Program Files (x86)\MARIS\Navtex\Inbox for Everyone and give full
read/write access. Sharing is needed to allow other computers on the network to
read incoming messages.
5. Open the ECDIS900 and check that incoming messages will close the Navtex book on
the acknowledge panel. A red Navtex book is also dropped at the ship’s present
position, or at the position of interest. This function can be turned on/off in the box.
Read the information by clicking the Navtex book on the acknowledge panel or by re-
clicking the icon on the chart.
NAVTEX SLAVE CONFIGURATION
1. Click “Start/Computer/Tools/Map” network drive…
Click “Browse…” and select the Inbox folder on the ECDIS900 computer running the
Navtex Server.
Place a tick mark in “Reconnect” at Logon. Click “Finish”.
You have now a direct access to this remote folder over the network.
Close all open windows, click “Computer” again and verify the remote Inbox folder
is listed under Network Drives.
2. On Navtex Inbox, click “Tools/Options/Position Settings”. Select “Accept the Position
From Sensor Monitor”. Click “Ok”.
3. Click “Tools/Options/Mailbase Path”. Click “Browse” and select the network drive you
have just created in step 1. Click “Ok”.
This is crucial. If you do not point to the shared network folder on the computer
running Navtex Server, nothing will show up.
4. Click “Options/Expiry”.
Select “Enable Auto Check” and set it to 3 days.
This concludes the slave setup.