Simrad ES 18 - DATASHEET REV C, Руководство по установке

Страница: 25 / 88

404770/B
23
2 Based on the shape of the transducer housing, and the mounting devices available,
determine the installation method.
3 Design, manufacture and mount the necessary fairing, installation blister, keel box
and/or tank that is required to mount the transducer.
4 Install the bushing.
5 Design, manufacture and mount the steel conduit for the transducer cable.
6 Unpack the transducer from its transport crate.
7 Position the transducer under the mounting location.
8 Pull the transducer cable up through the steel conduit.
9 Tighten the packing nipple on the cable gland properly to avoid leaks.
10 Mount the transducer.
11 Seal the top of the steel conduit to prevent water leaks.
12 Connect the transducer cable to the transceiver.
• Cable layout and interconnections, page 37
13 If your vessel will operate in waters with a lot of marine growth, consider applying
a thin layer of anti-fouling paint to the transducer face.
Related topics
Installing the transducer, page 21
Designing, manufacturing and mounting the installation hardware, page 23
Installing the cable gland, page 25
Designing, manufacturing and mounting the steel conduit, page 27
Unpacking the transducer from its transport crate, page 29
Installing the transducer cable, page 30
Mounting the transducer, page 33
Painting the transducer face, page 34
Designing, manufacturing and mounting the
installation hardware
Once the physical location of the transducer has been determined, the installation
hardware must be designed, manufactured and mounted.
Prerequisites
Before you can do this task, the following prerequisites must be met:
• All relevant vessel and transducer drawings must be available.
• All relevant work instructions, procedures and standards must be available.
• The physical location of the transducer has been determined.
Installing the transducer