SimpliFire • SF-ALLP50-BK, SF-ALLP60-BK, SF-ALLP72-BK Service Manual • 2044-960 Rev. C • 10/19
8
Note:
Flame Screen and Rotisserie must be removed
before Motor replacement can be completed.
1. Remove three (3) ST4X8 screws on the Motor
Bracket. See Figure 22.
2. Unplug the wire connector.
Motor Installation
(3) ST4X8
SCREWS
WIRE
CONNECTOR
Figure 22 Motor Removal
3. Install new Motor by following the removal steps
in reverse order.
Flame LED Light Board Installation
1. Remove screws used to attach the flame screen
bracket. See Figure 22.
FLAME SCREEN
BRACKET SCREWS
Figure 23 Remove Flame Screen Bracket Screws.
2. Remove flame screen bracket.
3. Unplug cable connection on each end of the LED
Board. See Figure 23.
4. Release the LED boards from plastic retainers. See
Figure 24.
Note:
Some retainers may require releasing an adhesive
prior to removal.
Figure 24 Unplug LED Board Cable Connections
CABLE CONNECTION LOCATION
5. To install replacement part reverse the installation
steps.
Note:
Flame Screen and Rotisserie must be removed
before LED Light Board replacement can be
completed.
LED BOARD RETAINERS
