SimpliFire • SF-ALLP50-BK, SF-ALLP60-BK, SF-ALLP72-BK Service Manual • 2044-960 Rev. C • 10/19
2
Stone/Media/Log Installation
1. Remove Glass.
2. Arrange the stone/media/log along the inset window
ledge at the front of the appliance.
Note:
Extra media is provided and may be
distributed based on consumer preference.
Not all media needs to be used.
Glass Replacement (Continued)
Installing Glass
3. Place the bottom edge of the glass in the channel on
the appliance.
4. Place the top edge of the glass against the appliance
and secure with two (2) ST4X8 screws removed in
step 1.
Figure 2 Glass Front Removal/Installation
1. Disconnect electrical service to the appliance. For
recessed electrical installations that are hardwired,
find and shut-off service at the breaker. For wall-
mounted installations that use a corded plug,
disconnect the cord from the receptacle.
2. Remove the glass front from the appliance. Use of
two people recommended.
3.
Follow specific instructions from page 1 and 2 for
removal of the front glass.
CAUTION! Two adults recommended for the removal
or installation of glass front.
Use caution when han-
dling glass. Failure to do so could result in personal injury
or property damage.
Preparation for Component Installation
ST4X8 SCREWS
Trim Removal
Trim is shipped attached to the appliance.
Note:
Trim must be installed before the appliance is
recessed in wall cavity.
1. Remove by removing the ST4X8 phillip screws
on the top, bottom and sides of the appliance See
Figure 3.
2. Pull Trim off from the front of the appliance. See
Figure 4.
SCREWS
TOP AND BOTTOM SCREW LOCATION
SIDE VIEW
SCREW LOCATION
SCREWS
Figure 3 Remove Trim Screws
Figure 4 Remove Trim
3. Install new Trim by following the removal steps in
reverse order.
Note:
Replacement trim will require removal of corner
shipping brackets prior to installation.
