7
SimpliFire • SF-ALLP50-BK, SF-ALLP60-BK, SF-ALLP72-BK Service Manual • 2044-960 Rev. C • 10/19
Note:
Flame Screen must be removed before Rotisserie
replacement can be completed.
1. Remove one (1) ST3X8 screw on the Rotisserie
support bracket. See Figure 21.
2. Remove Rotisserie from the rubber sleeve
connecting it to the motor.
Rotisserie Installation
Heater Assembly Installation
SIX (6) ST4X8 SCREWS
Figure 18 Heater Assembly Screw Location (bottom view)
4. Install new Heater Assembly by following the
removal steps in reverse order.
1. Remove six (6) ST4X8 screws on the heater top
securing to the bottom of the appliance. See Figure
18.
2. Unplug the wire connector. See Figure 19.
3. Remove the Heater Assembly.
WIRE CONNECTION
Figure 19 Unplug / Remove Heater Assembly
Flame Screen Installation
REMOVE ST4X8 SCREWS
Figure 20 Flame Screen Removal
2. Remove the Flame Screen.
3. After removal of the Flame Screen, the Rotisserie
Assembly, Flame LED Assembly and the Motor may
be replaced.
4. Install Flame Screen by following the removal steps in
reverse order.
1. Remove ST4X8 screws holding the Flame Screen in
place. See Figure 20.
ST3X8 SCREW
RUBBER SLEEVE
Figure 21 Rotissserie Removal
3. Install new Rotisserie by following the removal steps
in reverse order.
