6903-002008 <01>
8
[01]
[01]
2
Mount the Wall Plate
Wood stud
5.5mm
(7/32 in.)
13 mm
(1/2 in.)
2-1
Locate studs
2-2
Mark the wall
For assistance in determining wall plate location, see Height
Wizard at simplicityav.com.
Level the wall plate
[01]
and mark the hole locations.
2-3
Drill pilot holes
2-4
Tighten lag bolts
CAUTION:
Avoid potential injuries or property damage!
Pilot holes
MUST
be drilled to a depth of 75 mm (3 in.), using
a 5.5 mm (7/32 in.) diameter drill bit.
75 mm
(3 in.)
CAUTION:
Avoid potential injuries or property
damage! Improper
use
could
reduce
the
holding
power
of
the
lag
bolt.
To
avoid
potential
injuries
or
property
damage
Ù
DO NOT
over-tighten the lag bolts
[05]
.
Ù
Tighten the lag bolts
[05]
only until the washers
[06]
are pulled fi rmly against the wall plate
[01]
.
[05]
[06]
41- 61cm
(16-24 in.)
< 16 mm
(5/8 in.)
Verify the center of the studs using an awl, a thin nail, or an
edge to edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!
Ù
Any material covering the wall must not exceed 16 mm
(5/8 in.).
Ù
Minimum wood stud size: common 2 x 4 in (nominal 1.5 x
3.5 in).