Citation - 52” & 61” Mower Decks
www.simplicitymfg.com
6
F
A
C
D
B
Figure 10. Install Top Loop
A. Top Loop
B. Upright Tube
C. 1/2” x 3” Bolt GD.5
D. Retainer Pin Assembly
E. 1/2”
Side
Lock
Nut
F. Rubber
Stop
A
C
D
E
E
D
C
B
B
Figure 9. Upright Tube Orientation
4. Install the top loop (
A, Figure 10
) onto the upright
tubes (
B
). From the outside, install the 1/2” x 3” bolt
(
C
) through the retainer pin assembly (
D
), then through
the top loop and upright tube and shown in FIgure 10.
Loosely install the 1/2” side lock nut (
E
). Repeat for
other side.
5. Tighten the hardware securing the upright tubes to the
frame and bumper (
see Figure 8
). Torque the hardware
to 75 ft. lbs. (102 Nm).
6. Tighten the 1/2” x 3” bolts and hex side lock nuts
(
C & E
) securing the top loop (
A
) to the upright tubes
(
B
). Do not over-tighten. The top loop should pivot
snugly with the retainer pins removed.
7. Raise the top loop (
A
) until the rubber stops (
F
) contact
the upright tubes.
8. Push or pull the top of the roll bar forward against the
rubber stops and install the retainer pins and hair pin
clips to secure the roll bar in the raised position.
Not
for
Reproduction
