Citation - 52” & 61” Mower Decks
www.simplicitymfg.com
14
Lubrication
Lubricate the unit at the locations shown in Figures 31
through 34 as well as the following lubrication points.
Grease:
• front caster wheel axles & yokes
• deck lift pivot blocks
• mower deck spindles
• mower deck idler arm
Use grease fittings when present. Disassemble parts to
apply grease to moving parts when grease fittings are not
installed.
Not all greases are compatible. Use automotive-type lithium
grease.
Oil:
• control handle pivots
• seat plate pivots
• deck lift pivots
• discharge chute hinge
Generally, all moving metal parts should be oiled where
contact is made with other parts. Keep oil and grease off
belts and pulleys. Remember to wipe fittings and surfaces
clean both before and after lubrication.
Lubricating the Front Casters
NOTE: Front casters should be lubricated annually.
1. Remove the 1/4-28 bolt (
A, Figure 34
) that is screwed
into the front caster and install a 1/4-28 grease fitting.
2. Grease the front caster.
3. Remove the 1/4-28 grease fitting and re-install the
1/4-28 bolt.
4. Repeat process for the other side of the unit.
Figure 33. Deck Lift Linkage Pivots
Figure 32. Control Handle Pivots & Seat Plate Pivots
Figure 34. Front Caster & Wheel
A, 1/4-28 Bolt
Figure 31. Deck Lubrication
A
Not
for
Reproduction
