28
MAINTENANCE
EASY-TURN™ CABLE ADJUSTMENT
If the Easy-Turn™ cable has stretched, the gears will not disengage when
the control lever is activated. Adjust the cable using the following proce-
dure.
1. Turn the engine off and disconnect the spark plug wire.
2. Loosen the jam nut (see Figure 33).
3. Turn the adjustment nut to lengthen or shorten the cable. The cable
should be tightened just until all slack is removed from the lever,
however it must not engage the Easy-Turn™ release without depress-
ing the control lever.
4. Tighten the jam nut.
Adjusting Easy-Turn™ Cable
Figure 33
AUGER SHEAR PIN REPLACEMENT
The augers are secured to the auger shaft with special shear pins that are
designed to break if an object becomes lodged in the auger housing. Use
of a harder grade shear pin will reduce the protection provided by the
shear pin.
WARNING: Do not go near the discharge chute or auger
when the engine is running. Do not run the engine if
any cover or guard is removed.
Under most circumstances, if the auger strikes an object which could
cause damage to the unit, the shear pin will break. This protects the gear
box and other parts from damage.
The shear pins (A
A and B, Figure 34) are located on the auger shaft. Replace
a broken shear pin as follows.
1. Tap out the broken shear pin with a pin punch.
2. Install a new shear pin and cotter pin. Bend the ends of the cotter pin
down.
IMPORTANT: Do not replace shear pins with anything other
than the correct grade replacement shear pin. Use of bolts,
screws, or harder grade shear pins can result in equipment
damage.
Replacing Broken Shear Pin
Figure 34
B
A
B
A
Not
for
Reproduction
