11
SNOWTHROWER CONTROLS
A. Speed Select Lever
— Allows the operator to use one of five (5)
forward and two (2) reverse speeds (see Figure 2). To shift, move
speed select lever to desired position.
NOTICE: Do not move speed select lever while Traction
Control is engaged. This may result in severe damage
to the drive system.
B. Auger Control Lever
— Used to engage and disengage the
auger and impeller. To engage push down, to disengage release.
C. Chute Rotation Swtich
— Used to rotate the discharge chute
to the left or right.
D. Deflector Control Lever
— Used to control the angle of the chute
deflector (up or down).
E. Free-Hand
TM
Control
— After engaging the traction control (left
hand) and auger control (right hand), allows the operator to
release the auger control lever to use the other controls.
FEATURES AND CONTROLS
F. Easy-Turn
TM
Traction Control
— When engaged, allows the oper-
ator to release the left traction wheel, but allows the right wheel to
continue driving for easy turning.
G. Traction Control Lever
— Used to propel snowthrower for-
ward or reverse. Push down to engage, release to disengage.
H. Grip Warmer Switch
(rear of dash panel) — Used to warm the
hand grips (high or low).
I. Clean-Out Tool
— Used to remove snow and debris from the dis-
charge chute and the auger housing.
J. Skid Shoe
— Used to adjust the ground clearance of the auger
housing.
K. Headlight
— Used to operate the snowthrower in poor lighting
conditions.
Not
for
Reproduction
