Sime SUPERIOR Ci EI, Инструкция по установке и эксплуатации

Страница: 5 / 32

Supplied By www.heating spares.co Tel. 0161 620 6677
1.1 INTRODUCTION
The Sime “ SUPERIOR Ci EI ” is a range of wall mounted cast
iron boilers. The combustion system is fan assisted and has a
small balanced telescopic flue.
The appliance is supplied suitable for use with natural gas and
incorporated a direct burner ignition system.
The appliance is supplied with a concentric air and flue duct
suitable or wall thickness up to 740 mm [29 in] although
extension duct kits are available and may be used up to a total
flue length of 2.5 m [100 in].
The combined flue and air duct can exit the boiler from either
side or from the rear of the appliance.
A vertical extension and additional flue elbow may he fitted. If
required, the boilers can also be fitted with a separate twin
flue kit [see section 3 for details].
The boiler is designed for use with sealed primary water
systems and is supplied fully assembled and complete with
compression joints for simple connection to the heating
system. If the wall thickness is less than 0.5 in [19 in) the
appliance can be installed from inside the room without
access to the external wall although a wall liner is required.
This is available as an optional extra. Full details are given in
section 3.
The boiler can be used with a 230V room thermostat [class
II according to EN 60730.1].
1
1 TECHNICAL FEATURES AND DIMENSIONS
1.2 DIMENSIONAL DETAILS
Fig. 1
TABLE 2 - Minimum clearances
ABOVE THE APPLIANCE CASING 200 mm 8 in
AT THE R.H.S. 5 mm 1/4 in
AT THE L.H.S. 5 mm 1/4 in
BELOW THE APPLIANCE CASING 100 mm 4 in
IN FRONT OF THE APPLIANCE 450 mm 18 in
TABLE 1 - Connections
M CH Flow 22 mm Compression
R CH Return 22 mm Compression
G Gas Rc
1
/
2
”
1
/
2
” in BSP female
Superior 40 - 50 - 60 Ci EI Superior 80 Ci EI
P mm 290 350
A mm 150 192
C mm 49 35
D mm 167 227