Sime MURELLE EV 20 BFT, Руководство пользователя

Страница: 113 / 116

113
ES
PT
ENG
USER INSTRUCTIONS
WARNINGS
– In case of fault and/or incorrect equipment operation, deactivate it, without making any repairs or taking any direct action. Apply
only to qualified technical personnel.
– Boiler installation and any other assistance and/or maintenance activity must be carried out by qualified personnel persuant to
Standard CEI 64-8. Under no circumstances, the devices sealed by the manufacturer can be tampered with.
– It is absolutely prohibited to block the intake grilles and the aeration opening of the room where the equipment is installed.
– The manufacturer shall not be held liable for any damage caused by improper use of the appliance.
– This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
LIGHTING AND OPERATION
BOILER IGNITION (fig. 25)
The first ignition of the boiler must be car-
ried out by qualified technical personnel.
Successively, if it is necessary to start up
the boiler again, adhere strictly to the fol-
lowing instructions: open the gas tap to
allow the flow of the fuel. Move the main
switch of the system to “ON”. When fuel is
fed to the boiler, a sequence of checks will
be carried out and the display shows the
normal condition of the functioning, always
indicating the pressure of the system. If the
blue luminous bar is on, this indicates the
presence of voltage.
N.B.: To the first pressure the keys of the
controls (2) the display is illuminated, to
the successive pressure the operation
modality is active.
Winter
Press the key of the controls (pos. 2)
to activate the winter mode functioning
(heating and D.H.W.). The display will be as
shown in the figure.
Summer
Press the key of the controls (pos. 2)
to activate the summer mode functioning
(only the production D.H.W.). The display will
be as shown in the figure.
REGULATION OF THE WATER TEMPERA-
TURE FOR HEATING (fig. 26)
To set the temperature of the water for
heating, press the key
of the controls
(2). The first time the key is pressed, the
SET of heating circuit 1 is selected.
The second time it is pressed, the SET of
heating circuit 2 is selected. The display will
be as shown in the figure. Change the
values with the key
and
.
Standard visualisation will return to the
display by pressing the key
again, or
after 10 seconds if no key is pressed.
2
Fig. 25
Fig. 26
2
Circuito
riscaldamento 2
Circuito
riscaldamento 3
(impianto tre
zone)
Heating
circuit 2
APRE
OPEN