Sime 8115800, Руководство пользователя, Страница: 50 / 124

Installation, use and maintenance manual
MANUAL CODE: 6328406 Page 50 / 124
 Press and release the button or the
button within 15 seconds.
To change the time (minutes):
 Press and release the button when
changing the time: “ nn ” followed by two
numbers indicating the minutes are shown on
the display;
 Press and release the button or the
button within 15 seconds;
 Press and release the button or do not
touch the display for 15 seconds;
To exit the procedure:

Press and release the button until the
temperature under parameter P5 is shown or
do not touch the display for 60 seconds.
Alternatively:
 Press and release the button.
7.1.3.15 Setting the configuration parameters
To access the procedure:
 Make sure that the keypad is not locked
(section 7.1.3.3) and that there are no other
advanced procedures running;
 Press and hold the button and the
button for 4 seconds: “ PA ” (password) shows
on the display;
 Press and release the button;
 Press and release the button or the
button within 15 seconds to set “-19”;
 Press and release the button or do not
touch the display for 15 seconds;
 Press and hold the button and the
button for 4 seconds: the first parameter “SP1”
shows on the display.
To select a parameter:
 Press and release the button or the
button.
To change a parameter:
 Press and release the button;
 Press the button or the button to
increase or decrease the value of the
parameter (within 15 seconds);
 Press and release the button or do not
touch the display for 15 seconds.
To exit the procedure:
 Press and hold the button and the
button for 4 seconds or do not touch the
display for 60 seconds (any changes are
saved).
Turn the appliance off and back on again to
implement the changes to the parameters.
7.1.3.16 Restore factory settings
To access the procedure:
 Make sure that the keypad is not locked
(section 7.1.3.3) and that there are no other
advanced procedures running;
 Press and hold the button and the
button for 4 seconds: “ PA ” (password) shows
on the display;
 Press and release the button;
 Press and release the button or the
button within 15 seconds to set “149”;
 Press and release the button or do not
touch the display for 15 seconds;
 Press and hold the button and the
button for 4 seconds: “ dEF ” shows on the
display;
 Press and release the button;
 Press and release the button or the
button within 15 seconds to set “ 1 ”;
 Press and release the button or do not
touch the display for 15 seconds: “ dEF ” flashes
for 4 seconds on the display, then the
appliance exits the procedure;
 Disconnect the power supply to the
appliance.
To exit the procedure before completion:
 Press and hold the button and the
button for 4 seconds during the procedure (i.e.
before setting “1”: the appliance is not
restored).
7.1.3.17 COUNTING THE COMPRESSOR
OPERATING HOURS
7.1.3.17.1 General information
The appliance can store up to 9999 operating
hours for the compressor. If the number of
operating hours exceeds this value, “9999” flashes.
7.1.3.17.2 Displaying the compressor
operating hours
 Make sure that the keypad is not locked
(section 7.1.3.3) and that there are no other
advanced procedures running;
 Press and release the button: “Pb1” shows
on the display;
 Press and release the button or the
button to select “ CH ”;
 Press and release the button.
To exit the procedure:
 Press and release the button or do not
touch the display for 60 seconds.
Alternatively:
 Press and release the button.