SVD 800 HD
41
ENGLISHENGLISHENGLISHENGLISHENGLISH
15.1 Procedure d’installation au
plafond
ATTENTION:
SIM 2 Multimedia décline toute responsabilité pour
les dommages matériels et humains causés par une
installation mécanique, au plafond, erronée ou
négligée, toutes les opérations doivent être effectuées
par un technicien qualifié.
ATTENTION:
Vérifiez que le projecteur ne glisse pas sur la surface
où il repose.
ATTENTION:
Le plafond doit être suffisament solide pour pouvoir
supporter le poids du projecteur.
15 FRENCH INSTRUCTION
15.2 Projection frontale avec fixation
du projecteur au plafond
Pour installer le projecteur au plafond, utiliser le kit de
montage pour plafond (fourni avec le projecteur) et suivre
les instructions ci-dessous. Pour fixer le projecteur à un
plafond réalisé avec des blocs de béton ou avec des
briques, effectuer un trou de 12 mm de diamètre et de 65
mm de profondeur à l’aide d’une perceuse. Fixer au
plafond la grande patte de fixation se trouvant dans
l’emballage en utilisant les éléments d’accrochage ainsi
que les vis et les rondelles également fournis dans
l’emballage. Pour cela, UTILISER les trous extérieurs de
la patte et serrer avec un couple maximal de 25 Nm.
ATTENTION:
L’installateur devra vérifier si le mur peut supporter
jusqu’à 4 fois le poids total (patte de fixation, hardware
et partie électronique); l’épaisseur minimale du mur
de support devra être de 10 cm.
En cas de murs réalisés avec des blocs de béton ou avec
des briques, ne pas percer les trous nécessaires au
montage dans les joints de mortier. La distance entre les
éléments d’accrochage et la partie libre du mur de support
doit être supérieure à 18 cm. La patte de fixation devra
être fixée très soigneusement.
Fixer au plafond la patte de fixation se trouvant dans
l’emballage avec les quatre vis fournies.
Attention: La patte de fixation doit être solidement fixée
et être absolument parallèle à l’écran.
Poser le projecteur sur une table en position verticale (le
mettre sur le côté).
N.B.: Enlever les deux pieds avant.
Enlever les 2 vis ainsi que les 2 rondelles, introduire le
crochet gauche et le fixer en utilisant les mêmes vis et les
mêmes rondelles comme indiqué dans le dessin ci-
dessous. Répéter les mêmes opérations pour le crochet
de droite.
MUR
440
550
1
15
93
180
266
ECRAN
FRONT
440
93
=
=
RESPECTER LE
PARALLELISME
PATTE
Содержание SVD 800 HD
Страница 44: ......