Silvercrest SAS 7.4 LI A2, Руководство по эксплуатации

Страница: 9 / 67

- 6 -
2. Select a suitable installation location for the wall
holder
3
: It should present no problem with
taking the hand vacuum cleaner out of it and a
mains power socket for the power adapter
4
must be accessible.
3. Bore two holes with a spacing of approx. 68 mm.
Use the wall holder 3 to mark the boreholes:
this will ensure the spacing is correct. The bore-
holes must be suitable for 5 mm wallplugs.
4. Insert the wallplugs into the boreholes and, using the
screws, firmly screw the wall holder
3
to the wall.
5. You can place the nozzles on the lateral acces-
sories holder.
6. Connect the power adapter
4
to a mains power
socket.
Charging
Note:
Check to ensure that the on/off switch
6
has been
slid back (to the position "0") before starting the
charging process.
• Place the hand vacuum cleaner from above into
the wall holder
3
, so that the barrel plug
5
slips into the socket on the hand vacuum cleaner.
The charge indicator lamp
7
flashes red and
the charging process begins.
Important:
• When the hand vacuum again has enough ener-
gy to vacuum, the charge indicator lamp
7
glows green. This does not mean that the batte-
ries are fully charged. When the charge indica-
tor lamp
7
glows green, it means the batteries
are charged to about 80%.
• When charging is complete, which with fully
discharged batteries can take approx. 5 hours,
the appliance automatically switches to a trickle
charge (maintenance function). Nevertheless, in
order to avoid possible damage to the batteries,
do not leave the appliance permanently con-
nected to the power adapter
4 .
• First recharge the batteries when the suction
power of the hand vacuum cleaner is noticeably
weaker and the charge indicator lamp
7
green
is blinking.
Note:
The hand vacuum cleaner can also be charged
directly via the power adapter
4
. For this, remove
the barrel plug
5
with a slight twist from the wall
holder
3
and insert it into the socket on the hand
vacuum cleaner.
Operation
Warning!
The suction opening must always be open and
unblocked. Blockages lead to overheating and da-
mage to the motor.
Tips:
• Make certain that the dust filter
0
is always
inserted before using the appliance.
• As the maximum, suck up only as much liquid as
will fill the dirt container
q
to the MAX mark.
1. Take the hand vacuum cleaner from the wall hol-
der
3
or, if you do not use the wall holder
3
,
remove the barrel plug
5
from the socket.
2. If required, place the appropriate nozzle into the
suction opening:
• the crevice nozzle
2 , to clean narrow and
difficult to reach locations.
• the wet suction nozzle
1
to vacuum liquids up.
IB_109560_SAS7.4LIA2_FI_SE_DK_BE_NL.qxp 08.12.2014 10:42 Uhr Seite 6