30
15.2 Selecting a USB storage medium as data source
To play back audio tracks from a storage medium (e.g. USB stick, 2.5 “USB hard drive) connected to the USB connection, press
the “MODE” button to select “USB” as the data source.
Then the device will read the audio tracks that can be reproduced from the data storage medium and begins to play back the
first track.
Note:
The “USB” program source can only be selected through the “MODE” button if a USB storage medium has been
connected to the device.
When you pull off the USB storage medium or the plug of the USB connection cable from the device, the device
automatically switches back to the most recently selected program source.
Please note that only those USB storage media are recognized that have been formatted and written according to the
FAT16 or FAT32 standard. Hard drives formatted in NTFS or Linux are not recognized or supported.
15.3 Selecting an iPod
®
as data source
To select an iPod
®
as the data source, please connect it with the iPod
®
connection cable to the USB connection of the device.
The audio data stored on the iPod
®
can now be played in the same way as on the regular USB storage media.
Note:
Please note that the memory of an iPod
®
is differentiated into two different memory levels. The CRB-531 can only play back
data from the mass storage level. The iTunes
®
level is not supported.
15.4 Insert / remove SD/MMC
To insert an SD/MMC card, please press the button on the device. Then the operating
unit automatically flips down and uncovers the SD/MMC insertion slot. Now please insert
your SD/MMC card into the card slot with the contacts to the left until it audibly snaps into
position. SD/MMC cards with a storage capacity of up to 2 GB are supported.
To remove a SD/MMC card, press the unlocking button again. The front panel flips down.
Now please press the card that will be removed slightly into the device, until it snaps out.
Afterwards you can remove the card from the slot.
