- 4 -
1. Insert the leg pads
on the ends of the legs
where there is not a pre-drilled hole.
2. Assemble the legs
onto the storage plate
.
Insert screws through the pre-bored holes and
secure them with nuts from the inner side of the
storage plate
.
3. Place the top plate
on the legs
so that the
legs
lie against the pre-bored holes of the top
plate
from inside. The pre-bored holes in the
top plate
as well as those in the legs
must
lie opposite each other.
4. Insert screws through the holes and secure them
with the nuts.
Taking it into use
Before taking the table grill into use for the first time
clean it as described in the chapter “Cleaning and
care”.
Usage / grilling may only take place with the catch-
ment pan
r
intended for the purpose.
The voltage of the power source must tally with the
details given on the rating plate of the appliance.
Handling the grill
A good and even heat distribution is assured by the
integrated heating element
y
under the grill
q
.
Cleaning is made easier by the non-stick coating,
which prevents the adhesion of grillables.
• Place the assembled stand on a level surface.
Bear in mind that there needs to be a mains power
socket in the close vicinity.
• Fill the catchment pan
r
up to the max. marking
with water (ca. 1.3 ltrs). You can thus prevent the
burning-on of fats falling from the grillables and
make the subsequent cleaning of the appliance
easier.
• Install the splatter protection shield
w
on one
side (the later rear side) of the grill bars
q
should you be grilling greasy grillables. Additio-
nally, it serves well as a windbreak. Insert the
three tenons of the splatter protection shield
w
into the holes provided on one side of the grill
bars
q
. To do this, the splatter protection shield
w
must be lightly flexed.
• Place the grill bars
q
on the catchment pan
r
,
such that they are firmly seated.
• Place the grill on the stand. The 4 mounting pegs
on the top plate of the stand must encroach into
the depressions on the underside of the grill.
The grill must sit firmly on the stand.
Notice
You can also use the grill without the stand:
Place the grill on an absolutely level and even sur-
face. The surface must be insensitive to heat.
Otherwise, it could cause damage to the surface.
• Check to ensure that the grill bars
q
are correctly
placed onto the catchment pan
r
(see Fig.
q
).
• Insert the power cable with thermostat
i
into
the appliance such that the control lamp
u
is
facing upwards. Then insert the plug into a
mains power socket.
• Adjust the thermostat
i
to the desired temperature
setting. The grill starts to warm up and the indi-
cator lamp
u
glows.
• As soon as the indicator lamp
u
goes out the
grill has reached the adjusted temperature and
is ready for use.
IB_70351_STGR1600A2_LB7 12.12.2011 10:46 Uhr Seite 4
