Silvercrest 377187 2110, Руководство по эксплуатации

Страница: 23 / 320

■ 18 │
GB
│
IE
SRR 3.7 C3
–
Place the three shaving heads in the recesses of the cutting
unit
2
. Ensure that the notches on the edge of the shaving
heads rest on the catches in the opening.
–
Place the round blades into the shaving heads with the blade
tips to the front.
–
Press the two tabs of the retainers together and place them
back into the catches of the cutting unit
2
and release the tabs.
The cutting unit
2
is now reassembled.
5) Remove loose hairs from the shaver with the brush
e
.
6) Replace the cutting unit
2
on the shaver. Ensure that it snaps
into place and is seated firmly.
■ Clean the housing with a moist cloth.
NOTE
► If...
–
... the shaving result is noticeably poorer, ...
–
... you have to the shave the same spot repeatedly
to achieve a good result, ...
–
... the shave takes much longer than usual, ...
–
... there is visible damage to the shaving heads, ...
... the shaving heads/the cutting unit
2
must be replaced.
You can order the cutting unit
2
, incl. shaving heads from
our customer service (see section “Ordering spare parts”).
To replace the cutting unit
2
proceed as follows:
1) Take hold of the cutting unit
2
with three fingers in the
grip recesses
3
and pull it off.
2) Fit the new cutting unit
2
onto the shaver. Ensure that it
snaps into place and is seated firmly.