Silvercrest 324120 1901, Инструкция по эксплуатации и технике безопасности

Страница: 16 / 54

GB/IE/NI/CY 15
3. Press the week-timer button
9
:
4. Then the timer program is shown on the display.
With each pressing the button
9
, you will switch
to the next program - P1-P2-P3-P4-P5-P6-OFF. (See
Program Table on the fold-out rear side)
5. Confirm your selection by pressing the OK
button
5
.
6. Depending on the program selected as descri-
bed in Item 4 and depending on the time (day
and time), the week timer indicator
B
lights up
or blinks in the display.
If values
A
and
B
are lit continuously, the selected
program is active or the device turns off automatically.
If values
A
and
B
are flashing, the selected pro-
gram is not active. Then the device switches off after
30 seconds again. In the meantime, the fan runs until
the standby mode. Values
A
and
B
continue to
blink until the program automatically intervenes and
turns the device on.
ADJUSTMENT OF THE MANUAL
TIMER PROGRAM (P6)
1. Turn on the device (see Device Starting).
2. Select the first or the second heating level. To do
so, press the heating level key
11
. The symbol
A
lights up on the display. See Chapter “Heating Le-
vel Setting”. Alternatively, you can select a desired
temperature (see chapter “Temperature Setting”).
Please note: The wall-mount ceramic fan heater will
be turned ON depending on the selected program and
run the last heating level or temperature you selected.
3. Press the shown week-timer button
9
:
4. Then the timer program is shown on the display.
Press and hold the week timer button
9
until "P6"
appears in the display.
5. Confirm your selection by pressing the OK
button
5
.
6. Now the number of the respective day of the week
is flashing (see the table). By pressing the plus
8
or minus
7
button, you can set the first day of the
week which the timer should be set for.
01. Monday 02. Tuesday
03. Wednesday 04. Thursday
05. Friday 06. Saturday
07. Sunday
7. Confirm your selection by pressing the OK
button
5
.
8. The number of the start time hours appears on the
display. You can adjust it by pressing the plus or
8
minus button
7
.
Please note: Please note that the start time must be
before the end time and that only hours (no minutes)
can be set. The start time and end time must relate to
the same day.
9. Confirm your selection by pressing the OK
button
5
.
10. The number of the end time hours appears on the
display. You can adjust it by pressing the plus or
8
minus button
7
.
11. After 5 seconds, you will automatically switch to
the next week.
12. Now you can set the start and end times for each
day of the week one after another, as described in
items 8-10.
Please note: If you want to disable the timer for a day of
the week, select start and end time "00".