12 GB/IE/NI/CY
Installation
Hang the device onto the wall. The device’s air outlet
should be at the bottom
E
Use the dowels
I
and
screws
H
included in the delivery.
Please note:
Make sure that the wall can
bear weights of at least 4.1 kg.
Drill two holes with a 6 mm drill and insert the sup-
plied wall dowels into them
I
.
Screw the fastening screws
H
into the wall dowels
I
. Each screw shall protrude to about 10 mm
H
.
PLEASE NOTE:
When drilling, make sure that you
do not damage concealed power lines!
The distance between the holes must be 31.5 cm
(see Figure 3).
The distance to the ceiling and walls must be at
least 30 cm.
The distance to the floor must be at least 2m (see
Figure 4).
Please note:
If the specified distances can not be
maintained, the device may not be mounted.
Please note:
If necessary, you will need a climbing aid
(e.g. a ladder) to carry out the installation
3
4
5
Place the heater onto the fastening screws
H
(see Figure 5).
Make sure that the fastening screws
H
are
straightly inserted into the holes (see Figure 6).
Now move the heater to the right and then down
to the position .
A
Uninstall
Install
B
Starting up
Connect the fan heater to a grounded and secured
socket. To supply the electric current to the device,
turn the ON/OFF switch
F
to the "I" position. The
device is now at the standby mode. Its display shows
the ambient temperature.
Now you can turn the fan heater ON and OFF, as
follows:
On the fan heater:
Press the Start/Stop button
G
. The device starts. By pressing the start/stop
button again
G
, you can turn the OFF.
Please note:
If necessary, a climbing aid is required to
press the ON/OFF button
F
or the start/stop button
G
on the device.
With the remote control unit:
Press the ON/OFF
button
1
on the remote control unit. The unit starts.
To turn the unit OFF, press the ON/OFF button
1
on it once more.
6
Содержание 324120 1901
Страница 3: ...6 5 4 3 1 2 7 8 11 10 9 D B C A 12 13 E ...