Silvercrest 297858, Руководство по эксплуатации

Страница: 29 / 115

SKMP 1300 D4
GB
│
IE
│
25 ■
Working with the blender
WARNING! RISK OF INJURY!
► Always allow hot fluids to cool down to a
lukewarm temperature (approx. 30–40°C)
before pouring them into the blender
6
.
WARNING! RISK OF INJURY FROM
SHARP BLADES/ROTATING DRIVE!
► Never put your hand into the attached
blender
6
!
► Remove the blender
6
only when the blade
1
is at a complete standstill.
► Do not operate the blender 6 without the
blender lid
0
, lid catch
.
and measuring
jug
!
.
► In the event of malfunction, switch the appli-
ance off and remove the plug from the wall
socket to prevent the appliance from being
switched back on unintentionally.
ATTENTION! PROPERTY DAMAGE!
► The drive shaft for the attachments -3
rotates while the blender 6 is in use. Never
use the mixing bowl and blender
6
at the
same time! This will overload the motor!
► When working with the blender
6
, we
recommend allowing the appliance to cool
down after 3 minutes of operation.
Proceed as follows to prepare the blender
6
for
operation. Use figure C on the rear fold-out page
as a guide.
1) Press the release lever
upwards and push
the swivelling arm downwards into the
working position.
2) Pull the drive unit lid
%
off to the right (see
fig. C/fold-out page).
NOTE
► Ensure that the rotary switch is turned
to "0" before you place the blender 6 on
the blender drive unit
,
. Otherwise, the
appliance will start immediately as soon as
the blender
6
has locked into place.
3) Place the blender 6 on the blender drive unit
, so that the lock tabs on the underside of
the blender 6 lock into the recesses on the
blender drive unit
,
. The arrow symbol ▼
on the blender
6
must line up with the arrow
symbol ▲ on the appliance. Twist the blender
6
clockwise (towards ) until it noticeably
locks into place.
4) Add the ingredients.
5) Attach the blender lid
0
:
–
Place the blender lid 0 on the blender so
that the lip of the blender lid
0
seals the
spout.
–
Attach the lid catch . so that the lock tabs
on the lid catch
.
slide through the gaps
in the blender lid
0
. The wide tab marked
with lock symbols ( ) must point at
the European scale (ml/litre), as in fig. 2.
Fig. 2