Silvercrest 288632, Инструкция по эксплуатации и правила безопасности

Страница: 38 / 158

SilverCrest SHSD 2600 A1
36 - English
5. Place a large mug (with a capacity of at least 250 ml) centrally on the holder filter (13).
6. Press the unlock button (6) for at least 3 seconds to unlock the device. A beep sounds and the
temperature (1) and volume display (2) flash. At the same time, the water temperature (5) and
water volume (4) buttons light up.

The device saves the last water temperature (1) and water volume (2)
settings.

If you do not press a button for 15 seconds after unlocking the device, it
locks itself again.
7. If necessary, press the water temperature button (5) repeatedly to select the value “rt”.
8. If necessary, press the water volume button (4) repeatedly to select the value “200”.
9. Press the start button (3) to produce the set volume of water.
10. The container placed on the holder filter (13) is then lit up and filled with water. Once the
process is complete, a series of beeps sound and displays (1) and (2) flash. When the unlock
button (6) is the only one still lit, you can remove the container from the holder filter (13).
11. Pour away the water.
12. Repeat steps 5 to 11 three more times before continuing with step 13.
13. Press the unlock button (6) for at least 3 seconds to unlock the device. A beep sounds and the
temperature (1) and volume display (2) flash. At the same time, the water temperature (5) and
water volume (4) buttons light up.

The device saves the last water temperature (1) and water volume (2)
settings.

If you do not press a button for 15 seconds after unlocking the device, it
locks itself again.
14. If necessary, press the water temperature button (5) repeatedly to select the value “100”.
15. If necessary, press the water volume button (4) repeatedly to select the value “200”.
16. Press the start button (3) to produce the set volume of hot water.
17. The container placed on the holder filter (13) is then lit up and filled with water. Once the
process is complete, a series of beeps sound and displays (1) and (2) flash. When the unlock
button (6) is the only one still lit, you can remove the container from the holder filter (13).
DANGER: Risk of burns
Do not remove the container while the water is being heated and filled. Always
wait until the filling process is complete (drops of hot water can still drip from
the hot water dispenser even after the beep sounds).
18. Pour away the hot water.
19. Repeat steps 13 to 18 three more times. The hot water dispenser is then clean and disinfected.
The hot water dispenser is now ready for use.
7.1 Overview of control panel
The device has 2 numeric displays and 4 sensor buttons which you can activate simply by touching.
Make sure you have dry fingers. Otherwise the touch contact may not be detected.