SilverCrest SMBC 30 A1
44 - English
9.2. Setting the time
To set the time, proceed as follows:
Switch the Micro Stereo System standby.
Keep the
CLOCK button [43]
on the remote control pressed until the hours display flashes.
Press the
▲ button [9]
or the
▼ button [10]
on the Micro Stereo System or the
▲ button
[52]
or
▼ button [48]
on the remote control to set the hours.
Press the
CLOCK button [43]
on the remote control. The minutes start flashing.
Press the
▲ button [9]
or the
▼ button [10]
on the Micro Stereo System or the
▲ button
[52]
or
▼ button [48]
on the remote control to set the minutes.
Press the
CLOCK button [43]
on the remote control to confirm the input.
In standby mode, the Micro Stereo System shows the time on the
display [2]
. While it is switched
on, you can display the time for a few seconds by pressing the
CLOCK button [43]
on the
remote control.
The clock can also be synchronised automatically from the RDS signal of a radio station. Proceed
as follows:
Switch the Micro Stereo System standby.
Press the
INFO button [28]
on the remote control to toggle between “TS ON” and “TS
OFF”.
TS ON = The clock is synchronised automatically (enabled upon factory delivery).
TS OFF = The clock is not synchronised automatically and must be set manually.
Switch the Micro Stereo System to Radio mode.
Tune in a station that broadcasts an RDS signal. This synchronisation may take a few minutes.
If the clock gets synchronised with the wrong time, select “TS OFF” and then set
the time manually.
9.3. Adjusting the volume
You can use the
Volume control [11]
on the Micro Stereo System or the
Increase volume
[34]
or
Decrease volume [35]
buttons on the remote control to adjust the volume.
The currently set volume level is shown on the
display [2]
.
Содержание 279334
Страница 1: ......
Страница 2: ......
Страница 3: ...V 1 35 Deutsch 2 English 30 Français 58 Nederlands 88 Čeština 116 Español 144 Português 172 ...
Страница 202: ......