AN633
Rev. 0.7
57
10.5. Standard Packet Transmission
The purpose of the standard packet transmission example code is to demonstrate how the radio can send packets
in FIFO mode. If any of the four push buttons are pressed on the wireless motherboard then the host MCU will load
the appropriate packet content in TX_FIFO and after that will send it. The payload is a pre-defined content, namely
“BUTTONx” where x can be 1, 2, 3, or 4. The used packet can be seen below:
*Note:
N < 62 byte
Figure 41. Transmission Flowchart
Table 10. Structure of the Standard Packet
Preamble
Sync Word
Payload
CRC
32–40 bits
2 byte
N* byte
2 byte
Содержание EZRADIOPRO Si4060
