SILENT ALERT SA3000 FIRE SAFE MANUAL 24/04/2015
Designed & Manufactured by Clofield Limited
Free technical helpline 01246 450789 www.silent-alert.co.uk
Pager unit
1.
Move keys A, B and 5 to the On position away from the belt clip as
shown.
2.
Switch pager on by moving the miniature key labelled OFF to the
left away from the belt clip. As the Pager is switched on the battery key
lights for 2 seconds then the pager should vibrate and each light on the
display will light up four times. If this does not happen it may be
necessary to charge the pager (see below).
3.
Immediately after the set up sequence the field strength will be
displayed on the keypad each time a poll signal is received
approximately once every four seconds.
Charger unit
1. Plug the Mains Adaptor into a 13 amp socket and connect the plug to the socket at the
back of the Fire Safe or Alarm Clock Charger.
2. Place Pager in charging slot to charge.
Illustration shows the mains adaptor (left)
and optional Pillow Pad / Strobe plug
(right) connected to the charger using the
strain relief features
