Silca UC 199, Руководство по эксплуатации

Страница: 48 / 107

Fig. 52
Lower the gauge and press START; the display will show first:
TEST key check
in progress !
And then:
To compare detected
quotes fit Gauge Z20
on reader clamp.
[START]
Remove the key from the reading clamp and fit the Z20 template in its place.
Fig. 53
ATTENTION: carefully clean the Z20 template, test key Z3 and clamps before gauging.
Lower the gauge and press START; the display will show first:
Gauge dimensions
reading in progress.
and then:
Adjustements:
X =-005 Y= +002
Save data?
No=STOP Yes=ENTER
The display will show the adjustments relating to the X and Y axes; the correction values are viewed automatically
(they are the difference between the value read on the key and the template value) (Fig. 54).
Fig. 54
Press ENTER to save the adjustments, which will be applied automatically to the cutting side L100 clamp.
ATTENTION: if the STOP key is pressed, the new settings will be lost. If so, only the previous
setting values will remain valid. The settings will be accepted only if the tolerances remain
within a range between -40/ +40 hundredths of a mm.
Operating Manual
UC199
Copyright Silca 2012
44