Silca Speed, Руководство по эксплуатации

Страница: 25 / 36

6.3 Replacing the tracer point
ATTENTION: remove the mains plug.
1) Loosen the screw (E2) (Fig.31).
2) Loosen the grub screw (E1).
3) Hold screw (E2) still, unscrew the tracer point (E) anticlockwise and remove.
4) Fit the new tracer point and screw down to the end of run.
5) Tighten the grub screw (E1).
6) Tighten the screw (E2).
7) Re-set the machine as described in chap. 4.2.
Fig.31
6.4 Depth regulation (clamp protection)
SPEED incorporates regulation to safeguard the clamps from the possibility of scraping against the tracer point
and cutter.
ATTENTION: the play between cutting tool/tracer point and clamps must be 0.2 mm.
Should it be different from this, proceed as follows:
ATTENTION: remove the mains plug.
1) Raise the carriage against the cutting tool and take to
the end of its run (Fig.32)
2) Release the nut (X1) with the spanner.
3) Use the Allen wrench to screw or unscrew the screw
(X2) in order to move the carriage away from or
towards the tracer point and cutting tool.
4) Tighten the nut (X1).
Fig.32
Operating manual
SPEED
Copyright Silca 2013
21