Silca Speed, Руководство по эксплуатации

Страница: 14 / 36

3 MACHINE INSTALLATION AND PREPARATION
The SPEED key-cutting machine can be installed by the purchaser and does not require any special skills.
However, some checks and preparation for use need to be carried out by the operator.
3.1 Checking for damage
The SPEED key-cutting machine is solid and compact and will not normally damage if transport, unpacking and
installation have all been carried out according to the instructions in this manual.
However, it is always advisable to check that the machine has not suffered any damage.
3.2 Environmental conditions
To ensure that the best use is made of the SPEED key-cutting machine, certain parameters must be borne in mind:
damp, badly ventilated sites should be avoided.
The ideal conditions for the machine are:
-
temperature: between 10°C and 40°C;
-
relative humidity: 60% circa;
-
room illumination: approximately 500 Lux.
3.3 Positioning
1) Place the key-cutting machine on a horizontal surface, solid
enough to take the weight (14 Kg).
-
to work with ease, we suggest that the workbench be
approximately the height of the operator’s hip.
-
it is important to leave clearance of at least 30 cm behind
the machine and on each side to ensure proper ventilation
(Fig.8).
2) Ensure that the machines voltage is the same as that of the
mains power supply, which must be properly earthed and
provided with a differential switch.
3) Connect the power supply cable to the power supply socket.
Fig.8
3.4 Description of work station
The key-cutting machine needs only one operator, who has
the following controls at his/her disposal:
• Main switch (H)
• Motor start switch (K)
• Carriage movement lever (A)
• Carriage handle lever (B)
• Gauge knob (Q)
• Clamps (D)
• Clamps knobs (D1)
Fig.9
Operating manual
SPEED
Copyright Silca 2013
10