Silca Speed, Руководство по эксплуатации

Страница: 23 / 36

6 MAINTENANCE
ATTENTION: for repairs or replacement of parts for maintenance, the ‘CE’ mark is guaranteed
only if original spare parts provided by the manufacturer are used.
Although the key-cutting machine does not require special maintenance, it is advisable to check and, if necessary,
replace the parts subject to wear, such as: the belt, cutting tool, brush, tracer point. Replacement is simple and
can be carried out by the operator.
CLEANING
Keep the carriage and clamps free of chippings from the cutting operations by cleaning with a dry brush.
ATTENTION: do not use compressed air!
ATTENTION: to keep the machine well maintained we recommend using protective oil, e.g.
WD40 or similar, applied to the burnished mechanical parts. This prevents oxidation of the
parts in question (clamps, guides, carriages...).
Before starting any type of maintenance (checks or replacements), read the instructions below:
• Never carry out maintenance or servicing with the machine switched on.
• Always remove the mains plug.
• Follow all the instructions in the manual to the letter.
• Use original spare parts.
• Always check that any screws or nuts removed when replacing a piece are properly tightened.
6.1 Replacing the brush
When the brush no longer cleans off the burrs it must be replaced as follows:
ATTENTION: remove the mains plug.
1) Remove the cover (P) by loosening the screws (P1) (Fig.27).
2) Slot the locking rod (provided) into the hole (F1) of the cutting tool shaft (Fig.28).
3) Use the Allen wrench to loosen the screw holding the brush in place (Fig.28).
4) Replace the brush and tighten the screw with the Allen key.
5) Remove the locking rod from the cutting tool shaft.
6) Place the cover (P).
Fig.27 Fig.28
Operating manual
SPEED
Copyright Silca 2013
19