Silca Speed, Руководство по эксплуатации

Страница: 21 / 36

5.1.3 Key cutting
ATTENTION: make sure the gauges (Q1) have been lowered.
When the key-cutting machine has been turned on by means of motor start switch (K) it is ready for cutting:
1) Take the carriage up to the tracer point/cutter and keep the tracer point on the cut (Fig.23).
2) Move the carriage from right to left to cut the key. In case of double cuts repeat the operation in the second
side of the key.
3) Turn off the machine with switch (K) before removing the duplicated key.
4) Remove the keys from the clamps.
5) Turn on the machine with switch (K) and smooth off the key edges by means of the brush (S).
Fig.23
5.2 Using the accessories
The accessories provided with machine to assist key-cutting are:
-
pins
-
bars
Using the pins
The pins must be inserted between the bottom of the jaw and the back of the key for keys with narrow stems, and
their purpose is to ensure that the key protrudes sufficiently to be cut properly (Fig.24-B, Fig.24-C).
For keys with narrow, thin stems, two pins must be used (Fig.24- B) the second one to give a secure grip on the
key.
If the key thickness is too fine to guarantee a good grip in the clamps, a pin must be used (Fig.24-A).
ATTENTION: the pins provided have two different diameters: 1,20 mm and 1,70 mm; It is
essential to use pins with the same diameters for locking both the original and the key blank.
Fig.24
Operating manual
SPEED
Copyright Silca 2013
17