Operating manual
Matrix ONE
Copyright Silca 2014
12
3.6
STARTING THE KEY-CUTTING MACHINE
1)
Connect the power lead.
2)
Turn on the key-cutting machine with the master switch (P). A beep sounds and for a second all the warning
lights (leds) on the key pad/control board (K) light up simultaneously on the machine front (blue vertical bar –
green vertical bar -2 red arrows) (Fig. 3).
3) When the beep stops only the blue warning light stays on to indicate that the machine is live.
Nota: if the conditions described above do not occur, see chap.6.7.
3.6.1
STARTING THE MOTOR
With the machine connected and on:
1)
press the luminous switch (Q) to power the motor (Fig. 11).
2)
Press the push button (D1) on the vertical axis lever (D) and lower the lever.
ATTENTION: if the motor does not start and the lever (D) will not move, check that the lever is
fully tightened.
A fl ashing warning light (W) signals that the motor is on (chap.3.6.2). Attention: cutter in motion!
3)
To turn off the motor release the lever (D) or turn off one of the 2 switches (P) or (Q).
3.6.2
CUTTER MOTOR ON WARNING LIGHT
There is a warning light (W) on the right-hand part of the machine
front (behind the clamps unit (Fig. 13).
When the cutter motor is on the warning light fl ashes.
Fig. 13
3.6.3
LED LAMP
When the key-cutting machine is turned on the lamp is off.
Lightly touch the button (J1) to turn the lamp on or off.
Fig. 14
W
J1
