Operating manual
Matrix ONE
Copyright Silca 2014
25
6.6
ADJUSTING/REPLACING THE VERTICAL CARRIAGE SPRING
If the vertical carriage (Z axis) seems loose it is advisable to adjust the spring and replace if necessary. Proceed
as follows:
1)
Switch off the machine and disconnect the power lead.
2) Remove the 6 screws (Y1) to detach the top safety guard
(Y) (Fig. 33).
3) Loosen the 4 screws (Y3) and remove the rear panel (Fig. 40).
4) Turn the machine so that its back faces the operator.
To increase spring tightness:
-
perform operations 1 and 2 shown in Fig. 42.
To decrease spring tightness:
-
perform operations 1 and 2 shown in Fig. 43.
5)
Replace the safety guard (Y) and secure with the 6 screws (Y1) (Fig. 33).
To replace the spring:
-
follow the instructions in points 1. 2. 3.
-
replace the spring and adjust tightness .
Y3
Fig. 40
Fig. 41
Fig. 42
Fig. 43
